About
Electrical & Computer Engineer building things that matter
I’m an Electrical & Computer Engineering student at Santa Clara University, currently a Networking R&D Hardware Design Intern at Hewlett Packard Enterprise. I work across the hardware stack, from PCB design and signal integrity to board bring-up, and just as comfortably on the embedded side, writing firmware and bringing up microcontrollers. What I enjoy most is owning a design end to end: laying out the hardware, then writing the firmware that runs on it.
Get in touchSelected work
Featured Projects
Internship @ Hewlett Packard Enterprise
10 MHz & 1PPS Reference Switching Circuit
Selected and qualified a replacement analog switch for a 10 MHz / 1PPS reference distribution circuit, then owned the redesign from schematic through bring-up and G.703 validation.
Internship @ MOVD
Stratos Pro V3
A ground-up redesign of a custom ESP32 board: upgrading to a newer ESP32 with Bluetooth and wireless connectivity, rerouting the layout around it, consolidating the power rails for ~15% better efficiency, and designing, fabricating, and hand-assembling a companion dev board to bring up firmware.
Personal
Formula SAE Electrical System Integration
Low-voltage signal routing and power distribution for the vehicle’s temperature and pressure sensing subsystems, with grounding, fuse protection, and connector current ratings analyzed across the car.